CNC Aluminum Hopup Chamber SV unit is specially designed to improve accuracy, durability and ensure consistent air seal for VFC SCAR-L/H AEG series. The Hopup Chamber SV unit has a precision rotary dial design for fine hopup adjustments, also re-engineered the hopup levers and concave nubs to work best with R-hop and Standard-Hop to keep the BBs shooting straight and accurate on every single shot. The Hopup Chamber SV unit is designed to accept the nozzle length from 21.00mm to 21.25mm on VFC SCAR-L and 38.50mm to 38.75mm on VFC SCAR-H, and also fully compatible with most aftermarket soft and hard rubber bucking without losing FPS or dropping BBs. The Hopup Chamber SV Housing is equipped with a new CNC Delrin Locking C-Clip design to hold barrel tight without wobbling and twisting. With the new extended sliding arms design on both side of the chamber housing, the hopup unit is always centered, straight and air tight at all times when closing the receivers.
***The UV LED Tracer and Electronic Module are optional add-ons to glow BBs in the dark. Operating Voltage from 7VDC - 15VDC (2-4 cells LiPo, 6-13 cells NiCad). (Sold separately)
***The Empty Magazine Detection Sensor and Electronic Switch Controller are optional add-ons to stop Motor/HPA firing when the magazine is empty. (Sold separately)
***Test results: FPS might be increased from 10FPS to 30FPS over stock setup. Please check your FPS!
1X CNC Aluminum Hopup Chamber SV unit
2X Strong Clear Vinyl Cover set
1X CNC Aluminum Standard-Hop Arm
1X CNC Aluminum R-Hop Arm
1X Silicone Rubber Standard-Hop Nub Damper
1X Silicone Rubber R-Hop Nub Damper
1X CNC Aluminum 4.5mm length Precision R-Hop Concave Nub
1X CNC Aluminum 6mm length Precision R-Hop Concave Nub
1X CNC Brass Threaded Slot Pin
1X CNC Delrin Locking C-Clip
1X CNC Barrel Brass Spacer
1X Brass Spacer Holder Oring
1X Steel Compression Spring
|Compatibility||VFC SCAR-L/H AEGs|
Product has been added to your shopping cart.